On plenty of older Chester County houses, the hose spigot pokes out through a thick stone or block foundation, and the part that actually controls the water sits on the basement side of that wall where nobody looks. That is why an outdoor faucet leaking in late fall deserves ten minutes of attention before the first hard freeze. A drip at the spout is a washer. A puddle on the basement floor behind the faucet is a split pipe, and January makes it worse.
Where the water comes out is the best clue you have. Work through the spots below in order, starting outside and finishing in the basement.
Water Around the Handle Points to Worn Packing or an O-Ring
Water seeping out around the stem while the faucet is open means the seal behind the handle has worn out. On older compression-style spigots that seal is packing material or an O-ring held in by the packing nut, the hex nut directly behind the handle. Turn the water on and watch. A leak that appears only while the faucet is open and stops when it is closed is almost always this seal.
A quarter turn on the packing nut with an adjustable wrench sometimes stops a light weep. Go easy. If the leak keeps coming back after a gentle tightening, the packing or the stem itself needs replacing, which means closing the water to that line first. Many homes have a small dedicated shutoff on the pipe in the basement right behind the outdoor faucet, and that is the one to close.
A Spout That Drips When Closed Has a Worn Seat Washer
A spout that keeps dripping with the handle fully closed is not sealing at the valve seat. On a standard spigot, a rubber washer on the end of the stem presses against a brass seat. Years of summer heat and winter cold harden that washer until it cracks, and minerals in hard or well water can pit the brass underneath it.
Cranking the handle tighter is the instinct, and it backfires. It chews up the washer faster and can strip the stem threads. Replace the washer and its brass screw, and if the drip returns within a few weeks, the seat is too rough to seal and the spigot is due for replacement.
Small drips add up faster than people expect. The EPA estimates that leaks in an average home can account for more than 9,300 gallons of water wasted every year (EPA WaterSense). On a private well, that is also extra run time on the pump for water that goes straight into the flower beds.
Spitting From the Top Cap Is the Vacuum Breaker
Many newer outdoor faucets have a small cap or knob on top called a vacuum breaker. Its job is to stop dirty water from a hose, say one lying in a bucket of fertilizer, from being siphoned back into your drinking water. A short spurt from that cap when you first open the faucet, or right as you close it, is normal.
A steady stream from the cap the entire time the water runs is not. The internal seal has failed, or a bit of grit is holding it open. These caps exist for a health reason, so the fix is to repair or replace the breaker, not to plug it or remove it.
Spraying at the Hose Connection Is the Easiest Fix of All
Check this before you take anything apart. If the spigot is dry with nothing attached but sprays once a hose, timer or splitter is screwed on, the problem is at the threads. A missing or flattened hose washer causes most of these, followed by cross-threaded fittings and cracked plastic splitters.
Drop a fresh rubber washer into the hose coupling and thread it on by hand until it is firm. If it still leaks with a new washer, look closely at the spigot’s threads. Dented or corroded threads will not seal no matter what you put on them.
A Wet Basement Wall Behind the Faucet Means a Split Frost-Free Hose Bib
This is the leak people miss. A frost-free hose bib has a long barrel that runs through the wall, sometimes a foot or more, with the actual valve at the far end inside the heated house. When you close the handle, water stops back at that inner valve and the barrel drains out through the spout.
The design works well until a hose is left attached on a cold night. The hose holds water in the barrel, the water freezes, and the barrel splits somewhere inside the wall. Nothing looks wrong from outside, and the faucet still shuts off normally. The damage shows up the next time you open it, when water sprays into the wall cavity or down onto the basement ceiling instead of out the spout.
Stains on the basement wall or ceiling directly behind an outdoor faucet, or a puddle that appears only while the spigot runs, point to this. Stop using that faucet. A split barrel cannot be patched. The whole hose bib has to come out, and how involved that is depends on whether the old one was soldered, threaded or crimped onto the pipe and what is between it and the basement.
Water can run inside a wall for weeks before a stain shows through. With every fixture in the house closed, read your water meter to check for a hidden leak. A dial that keeps creeping means water is going somewhere you cannot see.
Water on the inside of the wall is the one outdoor faucet problem that should not wait for a free weekend. Close the faucet’s interior shutoff if it has one and call Chesco Plumbing. Our Kennett Square plumbers answer 24/7 and replace split frost-free hose bibs as part of our plumbing repair work.
Repairs a Homeowner Can Take On, and Where to Stop
A new hose washer, a light tightening of the packing nut and checking the spigot with and without the hose attached are all reasonable Saturday jobs. A seat washer is too, provided the spigot has its own shutoff and the stem comes out without a fight.
Leave it to a plumber when any of these apply:
- water is showing up inside the wall or in the basement
- the spigot still drips after a new washer
- there is no separate shutoff and the whole house would have to go dry
- the pipe behind the faucet is corroded, bent or loose in the wall
- the house has old galvanized supply pipe, where twisting one fitting can start a leak at the next
A November Checklist for Every Spigot on the House
A few minutes in late fall prevents most frozen spigot problems.
- Disconnect every hose, splitter and timer. For a frost-free hose bib this matters more than anything else on the list. An attached hose is the most common reason they split.
- Close the interior valve on older standard spigots. Plenty of older houses still have plain spigots fed by a pipe with its own valve a few feet inside. Close that valve, open the outdoor faucet so the trapped water drains, and leave the outdoor handle open for the winter.
- Drain and store hoses. A hose full of water can freeze and crack, and one left attached defeats the frost-free design.
- Cover exposed faucets. An insulated foam cover helps, especially on north-facing walls that take the wind.
- Repair drips before the cold arrives. A faucet that drips keeps water moving into the cold part of the line, so fixing it is part of winterizing.
The rest of the house needs attention too. This plumbing winterization checklist covers crawl spaces, garages and homes that sit empty over the winter. If a pipe has already frozen, read the advice on frozen pipe repair before you put a heat gun anywhere near it.
The Upgrade That Saves Next Winter’s Headache
An old standard spigot with no interior shutoff, on a wall that faces the wind, is a good candidate for a frost-free replacement. The repair you do now also gets tested before the hose goes away for the season.
To have a worn spigot replaced with a frost-free model, schedule a visit with Chesco Plumbing online or call while the weather still lets you run water outside and test it.
If water is actively leaking or flooding, our 24/7 emergency plumber team serves homes across Chester County, day or night.
Frequently Asked Questions
Why does my outdoor spigot leak only when it is turned on?
Two causes cover nearly every case. If water comes out around the handle, the packing or O-ring behind it has worn. If water appears inside the basement or wall instead, a frost-free hose bib has probably split inside the wall and needs replacing.
Can I leave a hose connected to a frost-free spigot in winter?
No. A frost-free hose bib works only if the water in its barrel can drain after you close it. An attached hose traps that water, which can freeze and split the barrel inside the wall where you will not see the damage until spring.
How do I know if my outdoor faucet is frost-free?
Check from the basement side. On a frost-free model, the faucet body itself passes through the wall and joins the supply pipe well inside the house. A standard spigot connects right at the wall, and older ones usually have a separate shutoff valve on the pipe a short distance inside. If you are still unsure, the product markings or the home’s records may say, or a plumber can tell at a glance.
How can I tell if a hose bib froze and cracked?
Open the faucet with nothing attached and have someone stand in the basement and watch the spot right behind it. Dripping from the ceiling, a spreading wet patch, or weak flow at the spout while water appears indoors all point to a cracked barrel.
Should I install a frost-free faucet on an older home?
In most cases it pays off, especially where the old spigot has no interior shutoff or sits on an exposed wall. The valve moves inside the heated part of the house, so the only winter chore left is disconnecting the hose each fall.