You will want to know how to shut off water to your house at the exact moment you are least able to go looking, usually with a supply line spraying under a sink and a towel that is already soaked. Ten minutes spent now, on a dry afternoon, changes that. You find the valve, make sure it turns, and show everyone else in the house where it is.
Where the valve sits depends on where your water comes from. A large share of Chester County homes are on private wells rather than public water, and the two setups put the main shutoff in different places.
On Public Water, Follow the Pipe From the Foundation Wall
The service line from the street usually comes into the house below ground, through the basement wall or floor on the side facing the street. The main water shut off valve is normally within a few feet of where that pipe enters, often right beside the water meter.
Walk the front basement wall and look for a pipe rising from the floor or coming out of the wall, a meter with a small dial or digital face, and a valve on the house side of the meter. In finished basements it often hides behind an access panel, in a utility closet or behind the water heater. Homes on a crawl space may have it just inside the crawl space door.
Some houses have a valve on each side of the meter. Either one stops the water to the house. Use the one on the house side when you can, because the meter belongs to the water utility and the street-side valve is often treated as theirs too.
On a Private Well, Look Beside the Pressure Tank
A well system has no meter. Water travels from the pump in the well to a pressure tank, a tall tank in the basement or utility room that is usually blue, gray or tan, and from there into the house.
The main shutoff is the valve on the pipe leaving the pressure tank toward the rest of the plumbing. Closing it stops water to every fixture. If you will be working on the plumbing for a while, or the leak is near the tank itself, also switch off the breaker for the well pump so it does not keep running to rebuild pressure. A well pump circuit is usually labeled in the panel. If yours is not, find it now and label it.
Ball Valves and Gate Valves Close Differently
Look at the handle before you turn anything.
Ball valve. A straight lever handle. With the lever running in line with the pipe, water is on. A quarter turn so the lever sits across the pipe shuts it off. Ball valves are quick and dependable.
Gate valve. A round wheel handle. Turn it clockwise until it stops, which can take several full turns. Gate valves are common in older Chester County homes, and they are the type most likely to stick, drip at the stem or stop short of fully closing after years without being moved.
Once the valve is closed, open a faucet on the lowest level of the house to bleed off the pressure. If the water slows to a trickle but never stops, the valve is not sealing.
A Seized or Leaking Main Valve Needs a Gentle Hand
Old gate valves that nobody has touched in years are often frozen in place. Do not put a long wrench or a pipe extension on the handle. Old stems snap, and a broken valve on the main line is a far bigger problem than the leak you were trying to stop.
When the valve will not move, drips from the stem as you turn it, or will not fully stop the flow:
- work it with small back-and-forth movements instead of one hard twist
- leave it wherever it stops the most water if there is an active leak
- on public water, call your water utility, which can close the curb stop near the street
- plan to replace it with a ball valve once the emergency is over
The curb stop is a valve buried in a small box near the property line or the sidewalk. It takes a long key, and on most systems it belongs to the water provider, so let them operate it unless they tell you otherwise.
A stem that weeps after you turn an old gate valve can sometimes be stopped with a slight tightening of the packing nut just under the handle. If it keeps dripping, or the valve will not close, that valve is due for replacement.
A main shutoff that will not close, or one you cannot reach without moving half the basement, is best fixed on an ordinary weekday. Book a visit with Chesco Plumbing through our online scheduler and a licensed plumber will test the valve you have and replace a worn gate valve with a quarter-turn ball valve.
Protect the Water Heater When the Water Stays Off
For a quick shutoff, the water heater can be left alone. If the water will be off longer, or you need to drain lines, take care of it. On an electric heater, switch off its breaker so the elements cannot run in a tank that might be losing water. On a gas heater, turn the control knob to pilot or vacation. Restore it only once the water is back on and hot water runs steadily from a faucet, which tells you the tank is full.
Fixture Valves Stop One Leak Without Shutting Down the House
Not every leak needs the main closed. Most toilets, sinks, dishwashers and washing machines have small shutoff valves on their supply lines, behind or under the fixture. Close the one feeding the leak and the rest of the house keeps running. Many outdoor faucets also have an interior shutoff on the pipe in the basement.
These small valves stick too. Turn each one off and back on once a year. One that drips after you move it is a quick fix through our plumbing repair service, and it is far easier to replace on a calm day than mid-leak.
Label the Valve and Test It Twice a Year
A shutoff only helps if it works. Twice a year, perhaps when you change smoke detector batteries, close the main, confirm the water stops at a faucet, then open it fully again. Hang a bright tag on it. On a well, tag the pump breaker as well.
Show everyone in the household where it is, including older kids and anyone who house-sits. When something does go wrong, these steps on what to do first in a plumbing emergency pick up where closing the valve leaves off.
When the Leak Is on the Street Side of the Valve
Sometimes closing the main shows that the problem is between the street and the valve. If you still hear water running, or the meter keeps moving with the main closed and nothing open in the house, the leak is likely on the buried service line. This explainer on main water line repair covers what happens next, and these water line repair warning signs help you spot trouble in the yard and the basement. For pipes leaking inside your walls, see our water line repair service.
A Tagged Valve Beats a Frantic Search
The best time to learn the valve is on a dry day with no pressure on you. Once it is found, tested and labeled, a burst supply line becomes a mess you can mop instead of a ceiling you have to replace.
Water coming through a ceiling right now is a different matter. Close what you can and call Chesco Plumbing, where the phones are answered 24/7, and a plumber will help you get the water stopped first.
If water is actively leaking or flooding, our 24/7 emergency plumber team serves homes across Chester County, day or night.
Frequently Asked Questions
Where is my main water shut off usually located?
On public water, it is usually in the basement or crawl space where the service line enters, often next to the meter on the street-facing wall. On a private well, look on the outlet side of the pressure tank, where the line heads off to the rest of the house.
Can I shut off the water at the curb myself?
The curb stop near the street normally belongs to the water provider and needs a special key. Call the utility first. Many will close it for you, and turning it yourself can damage a valve you would then be responsible for.
Should the main water valve be left fully open?
Yes. Open it all the way once you are done. A main left partly closed restricts flow to the whole house, and on a gate valve it can wear the internal gate.
Should I turn off the water when I go away?
For longer trips it is a sensible habit, since it limits the damage if a supply line bursts while nobody is home. Set the water heater to vacation or pilot first, and in winter keep the heat on so pipes do not freeze.
Why does water still run after I close the main valve?
Either the valve is worn and not sealing, or the leak is upstream of it on the service line. A plumber can tell which by checking the valve and watching the meter with everything closed.